Low-Voltage Prewire in Dallas–Fort Worth

The best time to plan your technology is before the drywall goes up. Jetcam A/V prewires new homes, remodels, and commercial sites across Dallas–Fort Worth. While the walls are still open, we install the cable your TVs, WiFi, speakers, cameras, and smart home systems will need. Planning at this stage helps prevent connectivity problems later and saves the time and cost of fishing wire through finished walls. We'll map out every location with you.

What we do

• Cat6 network cable to TVs, offices, access points, and cameras
• Coaxial cable for TV service and antennas
• Fiber optic cable
• Speaker wire for surround sound and in-ceiling and outdoor audio
• Security wire and camera locations
• TV locations with in-wall boxes, including above-fireplace mounts
• Runs back to a central rack or panel, labeled for easy service

Why Jetcam A/V

• Prewire is a core service for both homes and commercial sites.
• The same team handles the finish: TV mounting, home theater, networking, and security cameras.
• Clean, organized work. See the rack and in-wall photos in our gallery.

FAQs

When should prewire happen?

After framing and before insulation and drywall. Timing depends on your builder's schedule, so bring us in early.

What if I don't know what I want yet?

It's usually worth running cable to likely TV, speaker, and access point locations now. Adding wire later, after the walls are finished, is harder.

Can you prewire during a remodel?

Yes. Any time walls or ceilings are open is a good chance to add the wiring you'll want later.

Can you coordinate with my builder?

Yes. We can work with your builder or contractor on timing and do a walkthrough to confirm locations.

Building or remodeling? Plan your wiring before the walls close, so your home is ready for the technology you want now and later. Get a Quote · Call (817) 720-0737